Read and observe
and
If the retaining straps
» Fig. 134
A
the lid will also raise the luggage compartment cover (hereafter only referred
to as "cover").
The cover can be removed from the vehicle and stowed behind the rear seat
backrests if required
» Fig.
135. Before removing the cover, the sunshade at
the back must be rolled
up» page
Removing
›
On both sides of the boot lid, unhook the straps
» Fig.
134.
1
›
Hold the raised cover and press on the two sides on the underside of the
cover in the area of the recess
›
Remove the cover in the direction of the arrow
Fitting
›
Place the fixtures
on the cover above the brackets
B
» Fig.
134.
›
Press on the two sides to the upper side of the cover in the region of the
mounts
. The fixtures
must lock into place of the recess
C
B
sides of the luggage compartment.
›
On both sides of the boot lid, unhook the straps
WARNING
Do not place any objects on the cover during the trip - There is a risk of
injury if you brake or have a collision!
108
Operation
Fig. 135
Luggage compartment cover
stowed behind the rear seats
on page 104 first.
are attached to the boot lid, then opening
81.
in the direction of arrow
A
.
C
.
2
on the side trim
C
C
.
A
CAUTION
Observe the following instructions to avoid canting and the subsequent
■
damage to the cover or the side trim.
The cover must be inserted properly and the load must not exceed the
■
height of the cover.
The cover must not be jammed in the surrounding seal of the luggage com-
■
partment lid when it is in the raised position.
There must be no object in the gap between the cover in the raise position
■
and the rear backrest.
Roll-up cover
Fig. 136 Roll-up cover: pulling out/rolling/removing
on both