Skoda OCTAVIA Owner's Manual page 258


Read and observe on page 255 first.
The tow bar can only be fitted if it is in the ready position.
1st step - applies to key version 1
›
Remove the cap from the lock
›
Insert key into the lock so that the green marking is pointing upwards.
A
›
Turn key in the direction of arrow
A
upwards » Fig. 301.
1st step - applies to key version 2
›
Remove the cap from the lock
›
Insert key into the lock so that the eye of the key is pointing downwards.
B
›
Turn the key in the direction of arrow
shows up » Fig. 301.
2nd step - applies to both key versions
›
Grip the tow bar below the protective cap.
›
Push release pin in the direction of arrow
C
ously push operating lever in the direction of arrow
D
» Fig. 302.
Operating lever remains locked in this position.
D
256
Driving
Fig. 302
2nd step: both key versions
so that the red marking is pointing
1
so that the conclusions release
B 2
to the stop, and simultane-
3
to the stop
4
Check the setting of the standby position
Fig. 303 Standby position: key version 1 / key version 2 / position of the
lever and the release bolt with two key versions

Read and observe on page 255 first.
Correctly adjusted standby position
Applies to key version 1 - the red marking on key

Applies to key version 2 - the eye of the key

Operating lever is locked in the lower position.
C

The trigger pin can be moved.
D

In the ready position, the key cannot be removed or turned into a different po-
sition. The ball bar is thus set ready for installation.
» Fig. 303
is pointing upwards.
A
is pointing upwards.
B