Driving Data (Multifunction Display) - Skoda Rapid Owner's Manual

Messages upon reaching scheduled service date
As soon as the due date for the service is reached, the flashing symbol  and
the message appears in the display for about 20 s after the ignition has been
switched on. An audible signal is also emitted.
Display the days and distance until the next service interval
You can press button » fig. 12
4
maining distance and days until the next service interval whenever the ignition
is switched on.

Driving data (Multifunction display)


Introduction
This chapter contains information on the following subjects:
Operation
Information overview
Warning when exceeding the set speed
Memory
The driving data is displayed in the multifunction display when is ignition is
switched on. After the ignition is switched on, the information that was last
selected before switching off the ignition is displayed.
Operation
1)
Only valid for some countries.
on page 26 continuously to display the re-
Fig. 16
Buttons on the control lever
Operating the multifunction display
Press (up or down) - select data / Setting values
A
Press - show / confirm entry
B
Hold - Reset memory
Information overview
Overview of driving data (depending on the vehicle equipment).
Outside temperature - If the outside temperature drops below +4 °C, the tem-
perature indicator appears and a snowflake symbol  (display for low temper-
ature) flashes for a few seconds, then remains displayed together with the
outside temperature.
Driving time - driving time since last clearing the memory.
Current fuel consumption
33
stationary or driving at a low speed.
33
Average fuel consumption - is calculated continuously since the last clearing
34
of the memory. After erasing the memory, no data will appear for the first 300
34
m driven.
Range - Drive distance in km which can be covered with the existing tank ca-
pacity and with the same driving style. If you drive more efficiently, this value
can increase.
Distance driven - distance driven since the memory was last cleared.
Average speed - value constantly recalculated, for distance since last clearing
the memory. After erasing the memory, no data will appear for the first 300 m
driven.
Current Speed - digital speedometer.
Coolant temperature - If the coolant temperature is in the range 70-120 °C,
the engine operating temperature has been reached. If the temperature is be-
low 70 ° C, high engine speeds and straining the engine should be avoided. If
the temperature is over 120 ° C, the warning light lights up the instrument
cluster » page 28.
Warning when speeding - It is possible to set a speed limit.
» fig. 16
- The display appears in litres/hour if the vehicle is
1)
Information system
33