Skoda OCTAVIA Owner's Manual page 168

›
Push the SIM card into the available slot with the cut-off edge to the left un-
til it "locks into place" » Fig. 196.
If a phone / phones was/were connected before inserting the SIM card with
the infotainment and telephone services on the SIM card are also selected,
then the connection is terminated to previously connected phones.
Use the SIM card for the first time
The first time you insert the SIM card in the external module, the following
menu appears.
›
Calls too - Data and telephone services are activated (the main menu phone is
displayed).
›
Data connections only - only the data services of the inserted SIM card are acti-
vated.
If you wish to change the activated services at a later time, go to the Tele-
phone main menu and tap on the  → Use SIM card only for data connection func-
tion surface.
Enter the PIN code and save
›
If the SIM card is protected by a PIN code, then the PIN code of the SIM card
must be entered.
›
Confirm the entered PIN code.
›
or: If you would like to save the entered PIN code in the device memory, then
tap the function surface  to save the PIN code and confirm it at the same
time.
Establish a data connection using the SIM-card
After selecting the services and entering the PIN code, if required, a data con-
nection menu is displayed.
›
Tap the function surface Connect.
If the network is not sufficiently set up, Infotainment prompts for network
settings.
›
Tap the function surface Network settings.
›
Select the data provider.
If your data provider is not available in the list, ask your provider whether one
of the displayed providers can be used.
›
To check the network settings and adapt them in accordance with your data
provider's instructions if necessary, tap on the Network settings function sur-
face.
166
Infotainment
The usage settings for data connection via SIM card can be configured in the
→  → Network → Data connection:.

Manual configuration of the data connection network (APN access point)
If the data connection is not established automatically or if you wish to config-
ure the network (APN access point) manually, proceed as follows.
›
Tap the sensor field and then the function surface  → Network → Network

settings.
›
Carry out manual configuration in accordance with your data provider's in-
structions.
›
To save the configured values, tap the Store function surface.
Change PIN code
›
In the Telephone main menu, tap on function surface  → PIN setup → Change
PIN.
›
Enter the new PIN code and confirm.
Remove SIM card
›
Press on the inserted SIM card.
The SIM card "jumps" into the eject position.
›
Remove the SIM card from the slot.
CAUTION
When inserting an incorrectly sized SIM card, there is a risk of damage to In-
■
fotainment.
Avoid using a an adapter for the SIM card as the SIM card may fall out while
■
driving due to vehicle vibrations - There is the risk of damage to the external
module.
If you let the SIM card protrude out from the slot, then it may fall out of the
■
slot while driving due to vehicle vibrations.
Note
If a SIM card is inserted in the external module and the option to use the SIM
card telephone services is selected, the currently connected telephones will be
disconnected. You can then only connect the additional telephone to the info-
tainment system.