Cruise Control System - Skoda OCTAVIA Owner's Manual

The target position of the trailer is indicated by the contour
›
Tilt the knob for the adjusting exterior mirror to adjust the trailer contour
to the target position.
›
Observe the direct vicinity of the vehicle and reverse carefully.
The set angle of articulation can be further corrected while reversing by tilting
the adjusting knob for the side mirrors.
›
Stop the vehicle/trailer combination in the required position.
If a forward gear is engaged or the D / S mode set, the system is deactivated.
To align the vehicle/trailer combination (trailer and vehicle in a line), tilt the ad-
justing knob for the exterior mirror in the direction of arrow
trailer contour pivots to the position
3
›
Carefully reverse and drive forwards until the desired position of the vehicle
combination is achieved.
Note
The outer mirror surfaces cannot be adjusted while the system is active.
Automatic brake intervention

Read and observe and
The systems is deactivated and an automatic braking intervention takes place
in the following situations.
▶ If, during the manoeuvring,  the button is pressed, the driver's door is
opened or the steering wheel is gripped.
▶ If the angle between the vehicle and trailer is assessed by the system as too
large during the manoeuvring procedure.
If a specific speed is assessed by the system as too high during the manoeu-
▶
vring procedure due to the current angle between the vehicle and trailer and
the driver does not react to the warning braking intervention.
234
Driving
.
3
» Fig.
1
.
4
on page 232 first.

Cruise Control System

3

Introduction
The Cruise Control System (CCS) maintains a set speed without you having to
actuate the accelerator pedal. The state where the CCS maintains the speed is
referred to hereinafter as the control.
WARNING
Please take note of the general points relating to the use of assistance
■
systems » page 213,
276. The
After pressing the clutch pedal, no interrupted control occurs! For exam-
■
ple, if a different gear is engaged and the clutch pedal is released, control is
continued.
Operation
Fig. 277 MAXI DOT display (monochromatic): Examples of CCS status
displays
in section Introduction.
