Computer and networking requirements
Computer requirements
Networking and Internet browser requirements
Chapter 2 • Preparing for installation
16
1039110-0001 Revision A
Power supply
type
AC/DC, 46 W
HT1000 satellite modem with 1
W radio only
P/N 1502015
This section lists the requirements for the computer or other device, network, and
browser to be used with the satellite modem.
The HT1000 satellite modem can be used with any device that supports Internet
Protocl (IP) and has a 10/100 BaseT Ethernet LAN port. Typically, the modem is
connected to a customer's computer. However, the HT1000 is self-hosted; it does not
require a computer for any of its functions.
Requirements for the computer to be used with the satellite modem are the same
for the laptop computer you use to install the modem. The computer should meet
the minimum requirements specified by the computer operating system
manufacturer and the following networking and browser requirements. Make sure
your laptop is configured to support DHCP.
Note: The satellite modem can be used with a Mac computer that meets these
requirements, but Mac computers are not supported as a tool for installing
the satellite modem.
• Ethernet port
• Ethernet Network interface card (NIC) installed on at least one computer, 10/100
BaseT
• Ethernet cable (provided)
• A web browser such as Internet Explorer with proxy settings disabled
Connecting a network - If the customer wants to connect a network to the satellite
modem, this requires an Ethernet hub or other such device. The customer must
supply and configure the hub and cables. Required IP address information is obtained
during commissioning.
CAUTION
Do not connect the power supply to the satellite modem, or connect the power
supply to a power source until you are instructed to do so.
Table 1: Power supply specifications
Part number
Electrical requirements
Input line voltage: 100 - 130 V,
1.5 A maximum
Input line frequency: 60 Hz AC
Rated power consumption: 46 W