Information Codes - Panasonic WORKIO DP-C262 Facsimile Manual

Information Codes

In the event of communication failures, Information Codes appear in the transmission result or in the
transaction journal.
When an Information Code is displayed, take necessary action as recommended in the table below.
For definitions of the Information Code not found here, refer to the User (U)/Jam (J)/Machine (E)
Error Codes in the Operating Instructions (For Basic Operations) of provided booklet.
Info. code
030 Document is misfeeding.
031
Document is too long or
jammed.
Document length exceeds 78.8
inches (2 meters) in
"Std" and "Fine" mode only. The
length limitation
for "Super Fine" and "600dpi"
mode, is subject to the
available Memory size.
061 ADF Cover is open.
400 During initial handshake,
receiving station did not respond
or communication error
occurred.
401 Remote station required a
Receiving Password to receive
the document. Remote station
does not have Confidential
Mailbox.
402 During initial handshake,
communication error occurred.
403 No polling capability at the
remote side.
404/405 During initial handshake,
communication error occurred.
406 Transmission Password does
not match.
Receiving Password does not
match.
Received from an unauthorized
station in Selective Reception
mode.
202
Problem
Reload the document properly.
Remove the document jam.
Adjust Original Guide.
Reload the document properly.
Remove the document jam.
Add SD Memory Card in the machine.
A4/Letter
Width
A3/Ledger
Width
Close the ADF Cover.
Check with the other party.
Reload the document and send again.
Check the remote station.
Reload the document and send again.
Ask remote side to set to be polled.
Reload the document and send again.
Check the password or the telephone number
in Address Book.
Action
Super Fine 600 dpi
(Max. (Max.
Length) Length)
55 in 24 in
(1400 mm) (600 mm)
39 in 17 in
(990 mm) (430mm)
Refer to
Operating
Instructions (For
Basic Operations)
Adding a Fax
Number into the
Address Book
(See page 165)