Linked Modes; Unlink The Scanner - Honeywell Xenon 1900 User Manual

Linked Modes

Locked Link Mode and Open Link Mode are the link modes that accommodate dif-
ferent applications. Scan the appropriate bar codes included in the Open Link and
Locked Link Mode explanations that follow to switch from one mode to another.
Default = Open Link Mode.
Locked Link Mode - Single Scanner
If you link a scanner to a base or an Access Point using the Locked Link Mode,
other scanners are blocked from being linked if they are inadvertently placed into
the base, or if the Access Point linking bar code is scanned. If you do place a differ-
ent scanner into a base, it will charge the scanner, but the scanner will not be
linked.
To use a different scanner, you need to unlink the original scanner by scanning the
Unlink Scanner bar code. (See
Open Link Mode - Single Scanner
When newly shipped or defaulted to factory settings, a scanner is not linked to a
base or an Access Point. A link is established when the scanner is placed into a
base, or an Access Point linking bar code is scanned. When in Open Link Mode, a
new link is established when a new scanner is placed in the base, or you scan an
Access Point linking bar code. Each time a scanner is placed into a base or scans
an Access Point linking bar code, the scanner becomes linked to the base or Access
point and the old scanner is unlinked.

Unlink the Scanner

If a base or an Access Point has a scanner linked to it, that scanner must be
unlinked before a new scanner can be linked. Once the previous scanner is
unlinked, it will no longer communicate with the base or Access Point. To unlink the
scanner from a base or an Access Point, scan the Unlink Scanner bar code below.
Xenon/Granit User Guide
Locked Link Mode
(Single Scanner)
Scanner Modes, page 54.)
* Open Link Mode
(Single Scanner)
Unlink Scanner
55