Override Locked Scanner; Out-Of-Range Alarm; Alarm Sound Type - Honeywell Xenon 1900 User Manual

Override Locked Scanner

If you need to replace a broken or lost scanner that is linked to a base or an Access
Point, scan the Override Locked Scanner bar code below with a new scanner and
place that scanner in the base, or scan the Access Point linking bar code. The
locked link will be overridden; the broken or lost scanner's link with the base or
Access Point will be removed, and the new scanner will be linked.

Out-of-Range Alarm

If your scanner is out range of the base, an alarm sounds from both your base and
scanner. If your scanner is out range of an Access Point, an alarm sounds from just
the scanner. The alarm stops when the scanner is moved closer to the base or
Access Point, when the base or Access Point connects to another scanner, or when
the alarm duration expires. To activate the alarm options for the scanner or the
base and to set the alarm duration, scan the appropriate bar code below and then
set the time-out duration (from 0-3000 seconds) by scanning digits on the
Programming Chart,
Note: The Access Point does not have a base alarm.
Note: If you are out of range when you scan a bar code, you will receive an error tone even if
you do not have the alarm set. You receive the error tone since the data could not be
communicated to the base or Access Point or the host.

Alarm Sound Type

You may change the alarm type for the scanner or a CCB01-010BT base by scan-
ning the appropriate bar code below and then scanning a digit (0-7) bar code from
the
The sounds are as follows:
56
beginning on page 341, then Save. Default = 0 sec (no alarm).
Base Alarm Duration
Programming Chart,
Override Locked Scanner
(Single Scanner)
beginning on page 341, then Save. Default = 0.
Scanner Alarm Duration
Xenon/Granit User Guide