High Priority Symbology
To specify the high priority symbology, scan the High Priority Symbology bar code
below. On the
as high priority. Locate the Hex value for that symbology and scan the 2 digit hex
value from the
None.
Low Priority Symbology
To specify the low priority symbology, scan the Low Priority Symbology bar code
below. On the
as low priority. Locate the Hex value for that symbology and scan the 2 digit hex
value from the
If you want to set additional low priority symbologies, scan FF, then scan the 2 digit
hex value from the
bology. You can program up to 5 low priority symbologies. Scan Save to save your
selection. Default = None.
Preferred Symbology Time-out
Once you have enabled Preferred Symbology and entered the high and low priority
symbologies, you must set the time-out period. This is the period of time the scan-
ner will search for a high priority bar code after a low priority bar code has been
encountered. Scan the bar code below, then set the delay (from 1-3,000 millisec-
onds) by scanning digits from the
then Save. Default = 500 ms.
Xenon/Granit User Guide
Symbology Charts
on page 327, find the symbology you want to set
Programming Chart,
High Priority Symbology
Symbology Charts
on page 327, find the symbology you want to set
Programming Chart,
Programming Chart,
Low Priority Symbology
Preferred Symbology Time-out
beginning on page 341, then Save. Default =
beginning on page 341.
beginning on page 341, for the next sym-
Programming Chart,
* Preferred Symbology Off
beginning on page 341,
135