Scanner Name
You may assign a name to each scanner you are using for identification purposes.
The default name is in the format "ScannerName_Model_SN_XXXXXXXXXX" Per-
form the rename operation using either the bar codes on
the serial command :ScannerName:BT_NAMNewName. where ScannerName is
the current name of the scanner, and NewName is the new name for the scanner.
To rename scanners with sequential, numeric names, scan the bar codes below.
Scan the Reset code after each name change and wait for the scanner to relink to
the base before scanning a bar code to rename the next scanner.
104
0001
0003
0005
0007
page
105, or by sending
0002
0004
0006
Reset
Xenon/Granit User Guide