Base or Access Point Address
Scan the bar code below to determine the address of the base or Access Point you
are using.
Scanner Modes
Your scanner is capable of working in single scanner mode, multiple scanner
mode, or with Bluetooth devices other than the charge base or Access Point.
Charge Only Mode
There may be times when you want to charge your scanner, but not link to the base.
For example, if a scanner is linked to an Access Point or other Bluetooth device and
you need to charge the scanner, but want to retain your existing link.
In order to program the base for Charge Only Mode, you must link a scanner to it.
Once the scanner is linked to the base, scan the Charge Only Mode bar code. Any
subsequent scanners placed in that base will charge without linking to it. The
scanner used to program the base remains linked to the base. To unlink this scan-
ner, scan
Note: When in Charge Only Mode, the scanner periodically wakes up and beeps. See "Power
Up Beeper" on page 5-111 to change this setting.
Charge and Link Mode
If you want to charge a scanner and link to the base, use Charge and Link Mode. If
the base is programmed for Charge Only Mode, you must link a scanner to it first in
order to program it for Charge and Link Mode. Scan the linking bar code on the
base to link the scanner, then scan Charge and Link Mode. Default = Charge and
Link Mode.
54
Unlink Scanner
on page 55.
Base Address
Charge Only Mode
* Charge and Link Mode
Xenon/Granit User Guide