Delete Last Code; Clear All Codes; Transmit Records To Host; Batch Mode Transmit Delay - Honeywell Xenon 1900 User Manual

Delete Last Code

If you want to delete the last bar code scanned when in Batch Mode, scan Delete
Last Code.

Clear All Codes

If you want to clear the scanner's buffer of all data accumulated in Batch Mode,
scan Clear All Codes.

Transmit Records to Host

If you are operating in Inventory Batch Mode (see
60), you must scan the following bar code to transmit all the stored data to the host
system.

Batch Mode Transmit Delay

Sometimes when accumulated scans are sent to the host system, the transmission
of those scans is too fast for the application to process. To program a transmit
delay between accumulated scans, scan one of the following delays. Default = Off.
Note: In most cases, a short (250 ms (milliseconds)) delay is ideal, however, longer delays
may be programmed. Contact Technical Support
information.
64
Total Records
Clear All Codes
Delete Last Code
Inventory Batch Mode
Transmit Inventory Records
(page xvii) for additional
Xenon/Granit User Guide
on page