Illumination Lights; Aimer Delay - Honeywell Xenon 1900 User Manual

Illumination Lights

If you want the illumination lights on while reading a bar code, scan the Lights On
bar code, below. However, if you want to turn just the lights off, scan the Lights Off
bar code. Default = Lights On.
Note: This setting does not affect the aimer light. The aiming light can be set using
Mode

Aimer Delay

The aimer delay allows a delay time for the operator to aim the scanner before the
picture is taken. Use these codes to set the time between when the trigger is pulled
and when the picture is taken. During the delay time, the aiming light will appear,
but the LEDs won't turn on until the delay time is over. Default = Off.
130
(page 131).
* Lights On
1 millisecond
500 milliseconds
Lights Off
250 milliseconds
* Off (no
Xenon/Granit User Guide
Aimer