Multiple Scanner Operation; Scanner Name - Honeywell Xenon 1900 User Manual

Batch Mode Transmit Delay Medium
(500 ms)

Multiple Scanner Operation

Note: Multiple Scanner Operation Mode allows you to link up to 7 scanners to one base or Access Point. You cannot join an
8th scanner until you unlink one of the 7 scanners or take a scanner out of range.
To put the scanner in multiple scanner mode, scan the bar code below. Once you scan this bar code, the scanner is unlinked
from the base or Access Point and must either be placed into the base, or you must scan the Access Point linking bar code in
order to relink.

Scanner Name

You may assign a name to each scanner you are using for identification purposes. For example, you may want to have a unique
identifier for a scanner that is receiving imaging commands sent from the base or Access Point.
The default name is in the format "ScannerName_Model_SN_XXXXXXXXXX" If you have more than one scanner linked to a
base, and they all have the same name, the first scanner linked to the base receives commands. When renaming a series of
scanners with identical names, unlink all except one of the scanners from the base.
Perform the rename operation using either the bar codes on
Name :BT_NAM NewName . where ScannerName is the current name of the scanner, and NewName is the new name for the
scanner. If you wish to change the names of additional scanners, link them one at a time and repeat the : ScannerName :BT_N-
AM NewName . command for each scanner.
To rename scanners with sequential, numeric names, scan the bar codes below. Scan the Reset code after each name change
and wait for the scanner to relink to the base or Access Point before scanning a bar code to rename the next scanner.
0001
0003
3 - 18
Multiple Scanner Operation
page 3-19, or by sending the serial command : Scanner-
Batch Mode Transmit Delay Long
(1000 ms)
0002