Button - Siemens SCALANCE XB-200 Web Based Management

5.4.12

Button

Description of the RESET button
The "RESET Button" is used to reset to factory settings.
You will find a detailed description of the function available with the button in the device
operating instructions.
On this page, the functionality of the button can be enabled or disabled.
Description of the displayed boxes
The following functions are possible:
● "Restore Factory Defaults" check box
Enable or disable the function "Restore Factory Defaults" function with the "RESET"
button.
Steps in configuration
1. To use the required functionality, select the corresponding check box.
2. Click the "Set Values" button.
SCALANCE XB-200 Web Based Management
Configuration Manual, 04/2015, C79000-G8976-C360-02
CAUTION
"Restore Factory Defaults" button function active during startup
If you have disabled this function in your configuration, disabling is only valid during
operation. When restarting, for example after power down, the function is active until the
configuration is loaded so that the device can inadvertently be reset to the factory
settings. This may cause unwanted disruption in network operation since the device
needs to be reconfigured if this occurs.
Configuring with Web Based Management
5.4 The "System" menu
109