Interlogix ZEROWIRE ZW-6404 Installation Manual page 79

4. Click Add.
5. Initiate LINK or ADD mode on Z-Wave device. See your Z-Wave device's manual for
instructions.
6. Note: If a Z-Wave device has been added before or to another system, you must first
remove it before adding it to this system. To do this, click Remove, then activate LINK
or REMOVE mode on the device.
7. Click Rooms.
8. Check you can see the device you just added. Click a button such as ON or OFF to
verify you can control the device.
Note: Access level is required for programming the Z-Wave devices into ZeroWire.
ZeroWire Installation Manual 79