Interlogix ZEROWIRE ZW-6404 Installation Manual page 105

Data entry formatting errors
• "Data must only contain the following characters"
• "Date must be of the form YYYY-MM-DD."
• "Day must be from 1 to 31"
• "Data entry must only contain the numbers 0 - 9 and A-F"
• "Data entry must only contain the numbers 0 - 9"
• "Data must be a number from X to Y"
• "Improper Time Value"
• "must be 4 to 8 digits
• "You must enter a user Number between 1 and 1048575"
• "PIN digits must be between 0 and 9"
• "PIN Must be 4-8 digits from 0-9"
• "Data must not contain the following characters []"
Z-Wave messages
• "Unavailable - Failed Device Function in progress" - An attempt was made to enter an add/
remove mode when the failed device mode is active.
• "Unavailable - Add mode active" - An attempt was made to enter an add/remove mode when
the add mode is active.
• "Unavailable - Remove mode active" - An attempt was made to enter an add/remove mode
when the remove mode is active.
• "Unavailable - Resetting Network" - An attempt was made to enter an add/remove mode when
the resetting mode is active.
• "Unavailable - Backing Up Network" - An attempt was made to enter an add/remove mode
when the backup mode is active.
• "Unavailable - Restoring Network" - An attempt was made to enter an add/remove mode when
the restore mode is active.
• "Busy, Try Again Momentarily" - This message is received when the Z-Wave module is
attempting to execute a command and a new command was submitted.
• "Not primary controller" - An attempt was made to perform device functions when not a primary
controller.
• "Device Not found in failed list" - An attempt was made to remove a failed device that is now
responding.
• "Remove Device failed - already in process" - An attempt was made to enter a remove mode
when the remove mode is active.
• "Replace Device failed - already in process" - An attempt was made to enter a replace mode
when the replace mode is active.
• "Remove Failed" - An attempt to remove a device from the network has failed.
• "Replace Failed"- An attempt to replace a device from the network has failed.
• "Function timed out or cancelled" Add/Remove/Replace function timed out.
• "Unavailable, Try Again Later" - This message is received when the Z-Wave module is still
initializing.
• "Command Failed" - A Z-Wave command has failed.
• "You must press Select to choose a set point" - A set point change was attempted without
selecting a set point to change.
• "There are no Failed Devices" - Displayed in the failed device dialog when no failed devices
detected.
ZeroWire Installation Manual 105