Omron F3SJ-A series User Manual page 139

Control unit
Appearance
Control unit
Appearance
Control unit
Appearance
Control unit
Appearance
Spatter protection cover (2 cables per set, common for emitter/receiver)
Appearance
Model name Output
Relay, 3a+1b contact - F39-JC A cable with connector on one
G9SA-301
Model name Output
G9SA-300-SC Relay, 3a contact
Model name Output
G9SB-301-B Auto reset, 3a+1b
contact
Manual reset,
G9SB-301-D
3a+1b contact
Auto reset, 2a
G9SB-200-B
contact
Manual reset, 2a
G9SB-200-D
contact
Model name Output
G9SX-AD322-T15 Solid-state output
(Instantaneous
output X 3, OFF-
delay output X 2)
Model name
F39-HJ In this table, the
number as the protective height (
F3SJ.When a spatter-proof cover is attached, operating range of
F3SJ is reduced by about 10%.Spatter-proof cover with 1970 or
higher of
use.
Note
end is required.
- F3SJ with PNP output can be connected.
- Type with 5a+1b contact is also available.
Note
- One set of F39-JC C cables with
connectors on both ends is required.
- When extending the cable length, use 1 set
of F39-JC C and multiple sets of F39-
JC B.
- F3SJ with PNP output can be connected.
- Cannot be used as a muting system.
Note
- F39-JC A cable with connector on one
end is required.
- F3SJ with PNP output can be connected.
- The thickness for 3a+1b contact type
output is 25 mm.
- The thickness for 2a contact type output is
17.5 mm.
Note
- F39-JC A cable with connector on one
end is required.
- F3SJ with PNP output can be connected.
- OFF-delay within 15 seconds can be set to
16 levels.
- Use as instantaneous output is possible by
setting OFF-delay output to 0 seconds.
- Can be configured for partial control and
total control.
- Relay unit can also be connected.
Note
in the model indicates the same 4-digit
in the model) of the
in the model is divided into 2 in combination to
Appendix
E
F3SJ-A
121
User's Manual