Reset Your Controller To Factory Defaults; Controller Default Settings - TRENDnet TEW-WLC100 User Manual

TRENDnet User's Guide

Reset your controller to factory defaults

Advanced > Administrator > Settings Management
You may want to reset your controller to factory defaults if you are encountering
difficulties with your controller and have attempted all other troubleshooting. Before
you reset your controller to defaults, if possible, you should backup your controller
configuration first, see "Backup and restore your controller configuration
page 12.
There are two methods that can be used to reset your controller to factory defaults.
 Reset Button – Located on the rear panel of your controller, see
Hardware Features" on page 2. Use this method if you are encountering
difficulties with accessing your controller management page.
OR
 Controller Management Page
1. Log into your controller management page (see
management page" on page 8).
2. Click on Advanced and click on Administrator, then click on Settings Management.
3. Next to Reset to Factory Default Settings and Reset, click Load Default. When
prompted to confirm this action, click OK.
© Copyright 2016 TRENDnet. All Rights Reserved.
settings" on
"Product
"Access you wireless controller

Controller Default Settings

Administrator User Name
Administrator Password
Controller IP Address
Controller Subnet Mask
Controller Default Gateway
Primary DNS Server
TEW-WLC100
admin
admin
192.168.10.200
255.255.255.0
192.168.10.1
192.168.10.1
13