Batch Configuration Upload And Firmware Upgrade; Batch Configuration Deployment - TRENDnet TEW-WLC100 User Manual

TRENDnet User's Guide
 WPA2: This is the most secure wireless encryption available today, similar to WPA
encryption but more robust. This encryption standard also supports the highest
connection speeds. TRENDnet recommends setting your access point to this
encryption standard. If you find that one of your wireless network devices does not
support WPA2 encryption, then set your access point to either WPA or WPA-Auto
encryption.
Note: Check the specifications of your wireless network adapters and wireless
appliances to verify the highest level of encryption supported. Below is brief
comparison chart of the wireless security types and the recommended configuration
depending on which type you choose for your wireless network.
Security Standard WEP
IEEE 802.11a/b/g
(802.11n devices
Compatible will operate at
Wireless 802.11g to connect
Standards using this standard)
Highest
Performance
Under This
Setting Up to 54Mbps
Encryption
Strength Low
Open System or
Additional Shared Key,
Options HEX or ASCII,
Different key sizes
Recommended Open System ASCII
Configuration 13 characters
*Dependent on the maximum 802.11n data rate supported by the device (150Mbps,
300Mbps, 450Mbps, 600Mbps, 800Mbps) or maximum 802.11ac data rate supported by
the device (433Mbps, 867Mbps, 1.3Gbps, 1.7Gbps).
© Copyright 2016 TRENDnet. All Rights Reserved.
WPA WPA2
IEEE 802.11a/b/g
(802.11n devices
will operate at
802.11g to connect
using this IEEE
standard) 802.11a/b/g/n/ac
Up to 800Mbps (11n)
or 1.7 Gbps (11ac)
or max. 11n & 11ac
Up to 54Mbps data rates.
Medium High
TKIP or AES, TKIP or AES,
Preshared Key or Preshared Key or
RADIUS RADIUS
TKIP AES
Preshared Key Preshared Key
8-63 characters 8-63 characters

Batch configuration upload and firmware upgrade

Batch Configuration Deployment

Basic > AP Management > Device List
The controller allows you to upload access point configuration to multiple wireless
access points from a single backed up configuration file. This feature can simplify
deployment and configuration of multiple wireless access points. The configuration file
must be backed up from one of the wireless access points directly. On TRENDnet
compatible access points you can back up the access point configuration on the
Management > Backup/Restore Settings under Export Settings. Create and save the
encryption key to secure the backup configuration file and click Export (default
filename: TRENDnet EAP_config.bin)
Batch configuration deployment can only be applied to the same model TRENDnet
access point. (ex. If using a configuration file exported from a TRENDnet TEW-821DAP,
the configuration can only be deployed to multiple TEW-821DAP access points only.)
1. Log into your controller management page (see
management page" on page 8).
2. Click on Basic, click on AP Management, and then click on Device List.
3. In the device list under the Select column, check the access points you would like to
deploy configuration. You can also check the box at the top of the Select column to
select all access points in the list.
4. At the top, click on Config Upgrade.
TEW-WLC100
"Access you wireless controller
21