Change Your Controller Administrative Login Password; Check The Controller System Information - TRENDnet TEW-WLC100 User Manual

TRENDnet User's Guide

Change your controller administrative login password

Advanced > Setup > Management
1. Log into your controller management page (see
management page" on page 8).
2. Click on Advanced and click on Setup, then click on Management.
3. Under the Administrator Settings section, in the Password field.
Note: The idle timeout setting is used to define the period of inactivity in the controller
management page before automatically logging out.
4. To save changes to this section, click Apply when finished.
Note: If you change the controller login password, you will need to access the controller
management page using the User Name "admin" and the new password.
Note: You can also change the device or system host name under Device Name Settings.
© Copyright 2016 TRENDnet. All Rights Reserved.
"Access you wireless controller

Check the controller system information

Advanced > Administrator > Status
You may want to check the system information of your controller such as system
uptime, device time settings, and firmware version.
1. Log into your controller management page (see
management page" on page 8).
2. Click on Advanced and click on Administrator, then click on Status
System
 Firmware Version – The current firmware version your controller is running.
 Time: The current time set on your controller.
 System Up Time – The duration your controller has been running continuously
without a restart/power cycle (hard or soft reboot) or reset.
LAN
 MAC Address – The current MAC address of your controller's wireless or
interface configuration.
 IP Address - Displays your controller's current IP address.
 Subnet Mask – Displays your controller's current subnet mask.
TEW-WLC100
"Access you wireless controller
10