TRENDnet TEW-WLC100 User Manual page 7

TRENDnet User's Guide
6. Click Advanced, click on Setup, and then click LAN Settings.
7. Configure the controller IP address settings to be within your network subnet, then
click Apply.
Note: You may need to modify the static IP address settings of your computer's network
adapter to IP address settings within your subnet in order to regain access to the
controller. The Default Gateway and DNS IP settings must be assigned to ensure the
wireless controller is able to check for available online firmware upgrades
8. Using an Ethernet cable, connect one of the five Gigabit Ethernet ports located on the
back of the wireless controller to your network (e.g. router, switch, etc.)
© Copyright 2016 TRENDnet. All Rights Reserved.
9. Access the wireless controller management page using the newly assigned IP address.
Note: You may need to revert to your computer's original IP address settings before you
can access the wireless controller with the new IP address settings.
10. Click Advanced, click Setup, then click on Firmware.
11. Click Check to check for available online firmware upgrades.
TEW-WLC100
5