Product Hardware Features - TRENDnet TEW-WLC100 User Manual

TRENDnet User's Guide

Product Hardware Features

© Copyright 2016 TRENDnet. All Rights Reserved.
Front View
Rear View

Reset Button – Press and hold this button for 10 seconds and release to
reset the controller to factory defaults. The ports LEDs will turn off to
indicate that the reset was initiated.

Gigabit Ports (1-5) – Connect to your LAN network and connect
additional network devices.

Power Port – Connect the included power adapter to your controller
power port and then to an available power outlet.
Note: Use only the adapter that came with your controller.

On/Off Power Switch – Push the controller On/Off push button to turn
your controller "On" (Inner position) or "Off" (Outer position).

*USB Port – Reserved for firmware upgrade, backup/restore
configuration functions.
*Note: Functionality is not available in initial shipping firmware will be
added in future firmware upgrade.

Security Slot – Can be used to with third party lock to physically secure
your controller to a specific location.
LED Indicators

POWER/SYSTEM LED
On : When the System LED is on, the device is receiving power.
: When the System turns off, the power adapter is not
Off
connected or the device is not receiving power.

LAN LED
On (Green) : Indicates that a network device (router, switch, access
point, computer, etc.) has been physically connected to
one of the five Gigabit ports (1-5).
Off : Indicates no physical Ethernet connection or no network
devices physically connected to any of the Gigabit ports
(1-5).
TEW-WLC100
2