Set Your Controller Date And Time - TRENDnet TEW-WLC100 User Manual

TRENDnet User's Guide

Set your controller date and time

Advanced > Administrator > Time
1. Log into your controller management page (see
management page" on page 8).
2. Click on Advanced and click on Administrator, then click Time.
3. Review the Time settings. To save changes to this section, click Apply when finished.
 Time: Displays the current device time and date information.
 Enable Daylight Saving: Check the option to enable daylight savings time and set
the annual range when daylight saving is activated.
© Copyright 2016 TRENDnet. All Rights Reserved.
"Access you wireless controller
 Automatically synchronize with Internet Time Server – Check the Enable NTP
Server option to set your controller date and time to synchronize with an NTP
(Network Time Protocol) server address (e.g. pool.ntp.org). Enter the NTP server
address next to Default NTP server, (e.g. pool.ntp.org). Click the Time Zone drop-
down list to select the appropriate zone and you can optionally change your NTP
Sync period.
Note: NTP servers are used for computers and other network devices to
synchronize time across an entire network.
TEW-WLC100
14