TRENDnet TEW-WLC100 User Manual page 21

TRENDnet User's Guide
o
Enabled – This setting allows you to enable or disable the wireless
radio on the selected band. If checked, this will enable the wireless
radio and if unchecked will disable the wireless radio.
o
Hide SSID – This setting allows you to enable or disable the primary
SSID broadcast on the selected band. If unchecked, the SSID broadcast
is enabled, if checked the SSID broadcast will be disabled. This setting
does not disable the wireless radio, only hides the SSID/wireless
network name visibility and prevents client devices from easily
discovering the AP.
o
SSID – This setting allows you to change the primary SSID/wireless
network name on the selected band.
o
Security – This setting allows you to set the wireless encryption type
for the primary SSID/wireless network name for the selected band.
If choosing WEP, WPA/WPA2-Personal:

Key - For WEP security, enter the encryption key to assign in
this field. For WPA-Personal or WPA2-Personal security, enter
the passphrase in this field.
Note: The WEP key index is Index 1.

This is the password or key that is used to connect your
computer to this access points wirelessly.
WEP Key Format HEX
Character set 0-9 & A-F, a-f only
64-bit key length 10 characters
128-bit key length 26 characters
WPA/WPA2-Personal Passphrase Format: 8-63 alphanumeric characters (a,b,C,?,*,
/,1,2, etc.)
© Copyright 2016 TRENDnet. All Rights Reserved.
ASCII
Alphanumeric (a,b,C,?,*, /,1,2, etc.)
5 characters
13 characters
If choosing WPA/WPA2-Enterprise:
Note: This security type requires an external RADIUS server which requires more complex
security configuration.

IP Address: Enter the IP address of the RADIUS server. (e.g.
192.168.10.250)

Port: Enter the port your RADIUS server is configured to use
for RADIUS authentication.

Note: It is recommended to use port 1812 which is typical
default RADIUS port.

Shared Secret: Enter the shared secret used to authorize your
controller with your RADIUS server.
o
Bandwidth Control – This setting allows you to set the maximum
download and upload rate limits per client for the primary SSID in bits
per second (bps). Add "m" to the end of the value to indicate megabits
per second (Mbps) or add "k" to the end of the value to indicate
kilobits per second. Check the option to enable the feature and
TEW-WLC100
uncheck to disable.
19