Bosch MUC6...RU Instruction Manual page 28

en Troubleshooting
Problem
Display screen
OPEn
Display screen
CLOSE
Display screen
E1~E6
Display screen
E0
Display screen
E1
Display screen
E2, E5, E6 or E7
Display screen
E3
Display screen
E4
Display screen
E8
Display screen
E12
If you are unable to solve the problem, always call the hotline!
You will find the telephone numbers at the back of these instructions.
28
MUC6-8_RU_8001018000.indb 28
Cause
Pressure locking handle
closed (N) for a preparation
programme without steam
pressure function.
Pressure locking handle
open (M) for a preparation
programme with steam pressure
function.
Fault in the appliance.
Incorrect pan inserted or pan not
recognised.
The steam pressure function
does not work properly.
The appliance has overheated.
Short-circuit in the appliance.
Mains voltage too high.
Mains voltage too low.
Communication fault
When selecting a programme
with a high temperature
(e.g."deep fry"), unsuitable
ingredients have been added
(e.g. water). The programme is
aborted to prevent overpressure.
Remedy
Open pressure locking handle (M)
to deactivate the steam pressure
function.
Close the pressure locking handle
(N) to activate the steam pressure
function.
Abort the preparation programme.
Disconnect the appliance from the
power supply. Switch the appliance on
again. If the problem persists, contact
customer service.
Insert the pan properly. If the display
persists for more than 20 seconds,
disconnect the appliance from the
power supply and contact customer
service.
Disconnect the appliance from the
power supply and restart. If the
problem persists, contact customer
service.
Disconnect the appliance from the
power supply and allow to cool down.
Restart the appliance once it has
cooled down.
Disconnect the appliance from the
power supply and contact customer
service.
Contact electricity provider or grid
operator. Have the power supply
checked by an expert.
Restart the appliance once it has
cooled down.
Remove the unsuitable ingredients
from the pan. Clean pan and then fill
correctly (e.g. oil for the programme
"фритюр" (deep fry)). Leave the lid
open depending on the programme
selected X "List of preparation
programmes" see page 23.
Restart preparation programme.
07.03.2016 10:38:05