Troubleshooting - Bosch MUC6...RU Instruction Manual

Troubleshooting

Problem
A programme starts as soon as
the appliance is plugged in.
The prepared meal is half-raw.
The prepared meal is burnt.
The appliance boils over.
LED does not light up.
The hotplate does not function.
Water is flowing out of the
appliance.
The pressure locking handle of
the appliance cannot be opened.
Steam constantly escapes from
the steam outlet, even though
the steam pressure function is
switched on.
Display screen
P
MUC6-8_RU_8001018000.indb 27
Cause
The "Auto-Restart" function
is continuing with an aborted
programme. X "Auto-Restart
function" see page 7
Filled beyond capacity.
The ratio of the amount of water
and the ingredients is incorrect.
Foreign objects in the appliance
interior.
The pan is deformed.
Fault in the appliance.
Fault in the sensor.
There is dirt underneath the pan. Thoroughly clean the pan and the
The pan is deformed.
Fault in the appliance.
Fault in the sensor.
Filled beyond capacity.
The temperature is too high.
The selected preparation
programme requires the meal to
be cooked with the lid open.
The appliance is switched off.
Fault in the power cord.
Fault in the appliance.
The hotplate is damaged.
The appliance features overflow
protection.
The condensation tank is full and
overflowing.
Food is obstructing the
overpressure lock and the
pressure locking handle is
blocked.
The valve plug is not properly
placed on the valve.
This is not an error. The steam is
released automatically.
Troubleshooting
Remedy
Press button H to stop the programme
and to enter standby mode.
Do not fill the pan beyond the mark
[ 4.0 litres ]!
Adjust the ratio of the amount of water
and the ingredients.
Remove all foreign objects. Do not use
any water for this purpose!
Contact customer service.
appliance interior.
Contact customer service.
Adjust the amount.
Reduce the temperature.
Open the lid of the appliance.
Switch on the appliance.
Contact customer service.
Contact customer service.
Remove water from condensation
tank. Remove the pan and use a
cloth to rub the appliance interior
dry. Ensure that no water enters the
appliance interior.
Proceed as described in chapter
X "Release steam manually" see
page 15. If the problem persists,
contact customer service.
Disconnect the appliance from the
power supply and allow to cool down.
Remove the steam outlet and place
the valve plug properly on the valve.
Wait until the steam has been released
completely or release steam manually.
en
27
07.03.2016 10:38:05