Bosch MUC6...RU Instruction Manual page 10

en Before using for the fi rst time
Caution!
Before inserting the pan, check that the
appliance interior is dry and clean.
15. Place lid insert
The pressure locking handle must be
opened (M). Place the lid insert on the
lid insert mount with the steam valve at
the bottom. At the same time, guide the
steam valve through the steam valve
opening. Tighten the fastening screw for
the lid insert clockwise on the lid insert
mount.
16. Close the lid
Press the lid down until it clicks into
place. Close the pressure locking
handle (N). For this purpose, rotate
the pressure locking handle as far as
possible in a clockwise direction.
17. Insert the valve plug
Place the valve plug in the steam
release chamber on the steam valve
and press down fi rmly.
Caution!
Make sure that the white steam release
lever is positioned below the valve plug.
18. Insert the steam outlet
Place the steam outlet on the lid from
above and press down fi rmly.
10
MUC6-8_RU_8001018000.indb 10
19. Insert the condensation water tank
Fold up the carrying handle. Hold the
tank by the sides at the top and insert at
the rear of the appliance.
20. Connect the supplied mains cable to the
appliance fi rst and then connect it to the
socket.
W Risk of fi re!
After plugging in, always check whether
a programme is run automatically
(Auto-Restart function). If an unwanted
programme starts running, press button H
to stop the programme and to enter standby
mode.
On the control panel, buttons B and G
and all LEDs briefl y light up once and a fi ve-
level audible signal sounds. Button B then
fl ashes. The appliance is in standby mode
and is ready for operation.
Caution!
Use only the supplied mains cable.
07.03.2016 10:37:57