Bosch MUC6...RU Instruction Manual page 12

en Preparation
1. Keep pressing button D until the
desired preparation programme is
selected.
The corresponding LED lights up in the
control panel and the pre-configured
preparation time for the selected
preparation programme flashes.
2. Press button G to start the preparation
programme.
The appliance heats up the pan until the
target temperature is reached. During
the heating phase, lines that light up in a
clockwise direction appear in the display.
Once the target temperature is reached,
the lines go out and the preparation time is
shown in the display.
The preparation process starts
automatically.
Note: When the programme [ паста ] (pasta)
or [ фритюр ] (deep frying) is selected, a
repeating audible signal is emitted and the
display and button G flash until the food
has been added and button G has been
pressed.
12
MUC6-8_RU_8001018000.indb 12
The preparation time counts down.
Cooking produces steam, which escapes
from the appliance to prevent excess
pressure from building up.
Increasing or reducing the
temperature during preparation
If the current temperature was set too high
or too low during the preparation, this can
be increased (by +10°C max.) or decreased
(by -10°C max.) accordingly during the
cooking process.
To increase the temperature, press and
hold button C. The current temperature will
be briefly shown on the display and will
then increase in 1°C increments until the
maximum value is reached (+10°C). Press
and hold the button until the temperature is
at the increased level desired.
To reduce the temperature, press and
hold button C. The current temperature will
be briefly shown on the display and will
initially increase in 1°C increments until the
maximum value is reached (+10°C). Once
the maximum value has been reached, the
display will jump back to the minimum value
(20°C lower). Press and hold the button
until the temperature is at the reduced level
desired.
To continue with the preparation
programme, press button G.
Note: If button G is not pressed, the
preparation programme will continue with
the temperature that was previously set.
When the preparation programme ends,
an audible signal sounds and the indicator
[ готово ] (finished) and button G light up,
or the keep warm function is activated.
The display flashes and shows "00:00".
07.03.2016 10:37:58