Bosch MUC6...RU Instruction Manual page 14

en Preparation
The indicators "low steam pressure" [ K ]
or "high steam pressure" [ L ] light up.
X "Preparation with steam pressure" see
page 13
Steam pressure function deactivated
To be able to select preparation
programmes without the steam pressure
function, the pressure locking handle must
always be opened (M). For this purpose,
rotate the pressure locking handle as far as
possible in an anti-clockwise direction.
The desired preparation programmes can
be selected in function selection mode
without the steam pressure function.
X "Preparation without steam pressure"
see page 11
There are 8 pre-confi gured preparation
programmes which can be used with
the steam pressure function. X "List of
preparation programmes" see page 23
W Risk of scalding!
■ Ingredients which are liable to froth up,
e.g. like milk and cream must not be
heated under steam pressure.
■ Do not use the steam pressure function
to deep fry food in oil under pressure.
1. Open the appliance. Open the pressure
locking handle for this purpose (M)
and press the opening button on the
basic appliance.
2. Fill the pan with the desired ingredients.
The measuring scale on the inside of
the pan can also be used to read the
quantity.
Caution!
■ Never heat up the appliance under
steam pressure without having added
water or other liquids beforehand. Add
at least 250 ml of water.
14
MUC6-8_RU_8001018000.indb 14
■ Fill the pan with a maximum of 3.3 litres.
Only fi ll the pan at most half-full when
preparing food that expands during
cooking, e.g. rice or dried vegetables.
3. Close the appliance. Press the lid
down for this purpose until it clicks into
place and close the pressure locking
handle (N).
An audible signal sounds. The steam
pressure function is switched on.
4. Press button B to access function
selection mode.
The desired preparation programme is
selected in function selection mode and all
settings of the appliance are made. Button B
and the indicators [ мой режим ] (my mode)
and [ K ] are permanently lit. Button G
fl ashes. "00:00" is shown in the display.
Note: If no input is made on the control
panel within 5 minutes, the appliance
automatically switches to standby mode.
5. Keep pressing button D until the
desired preparation programme is
selected.
The corresponding LED lights up in the
control panel and the pre-confi gured
preparation time for the selected
preparation programme fl ashes. The
indicator "low steam pressure" [ K ] or
"high steam pressure" [ L ] lights up. Press
button L to switch between [ K ] and [ L ].
07.03.2016 10:37:59