Panasonic KX-TDA100 Features Manual page 319

Parameter
Wink Signal Time Out
Start Signal Type
E & M TIE Line Type
E & M Sensitivity Out
Sending Caller ID to
TIE
Receiving Caller ID
from TIE
E & M Sensitivity In
Ringback Tone Service Assigns the ringback tone service.
PBX Dial Tone
Pause Time
Flash Time
Disconnect Time
Description
Selects the length of waiting time for the
Wink Signal after seizing a trunk.
Note
It is assignable only when Start Signal
Type is set to "Wink".
Selects the start signal type.
• Wink: The wink signal is transmitted to
the telephone company before the
incoming calls are received.
• Immediate: No wink signal is
transmitted.
Selects the type of E & M connection.
Selects the voice level for transmission.
Selects whether to send the Caller ID to the
TIE line.
Selects whether to receive the Caller ID to
the TIE line.
Selects the voice level for reception.
Assigns whether the system sends dial
tone to extension users who seize a T1
digital trunk line.
Selects the length of Pause Time.
Specifies the length of Flash Time.
Selects the maximum waiting time after
releasing the trunk line before getting it
again.
3.2 PC Programming
Value Range
64/128/256/512/1024/
2048/4096/8128 ms
Immediate/Wink
2/4 wires
-6/-3/0/+3 dB
Yes/No
Yes/No
-6/-3/0/+3 dB
Enable/Disable
Enable/Disable
1.5/2.5/3.5/4.5 s
None/16 × n (n=1–80)
ms
0.5/1.5/2.0/4.0/12.0 s
Feature Guide 319