Panasonic KX-TDA100 Features Manual page 205

Conditions
• SMDR Format
The following SMDR format can be set through system programming in order to match
the paper size being used in the printer:
a)
Page Length: determines the number of lines per page (
b)
Skip Perforation: determines the number of lines to be skipped at the end of every
page (
c)
Character Code: determines which code to be used; IBM ASCII or ISO-8859-1.
• The SMDR data is not deleted even if the PBX is reset.
• If the PBX is reset during a conversation, the call will not be recorded on the SMDR.
• If "*" marks are displayed for the date, time, ring, and duration (e.g., **/**/** **:****), the
date and time setting has been changed four or more times during the ring and duration
are counted.
• The following calls are regarded as two separated calls in the SMDR:
a)
Calls before and after the flash/recall/EFA signal is manually sent during a
conversation
b)
Trunk-to-trunk calls by Call Transfer, FWD or DISA (recording each as "incoming
call" and "outgoing call")
• The PBX waits for a preprogrammed time period (
between the end of dialling and start of the SMDR timer for outgoing trunk calls. When
the PBX has sent out all dialled digits to the telephone company and this timer expires,
the PBX starts counting the call. A display PT shows the elapsed time of the call. The
starting time and the total duration of the call are recorded on SMDR.
If the reverse signal detection has been set (
counting the call after detecting the reverse signal from the telephone company
regardless of the above timer.
• Serial Interface (RS-232C) Parameters
The following communication parameters can be assigned for the Serial Interface (RS-
232C) port (
a)
New Line Code: Select the code for the personal computer or printer. If the personal
computer or printer automatically feeds lines with carriage return, select "CR." If not,
select "CR+LF."
b)
Baud Rate: A baud rate code indicates the data transmission speed from the PBX
to the personal computer or printer.
c)
Word Length: A word length code indicates how many bits compose a character.
d)
Parity Bit: A parity code indicates what type of parity is used to detect an error in the
string of bits composing a character. Make an appropriate selection depending on
the requirements of the personal computer or printer.
e)
Stop Bit Length: A stop bit code indicates the end of a bit string which composes a
character. Select an appropriate value depending on the requirements of the
personal computer or printer.
SMDR Skip Perforation).
New Line, Baud Rate, Data Bits, Parity, Stop Bits).
1.23 Administrative Information Output Features
Call Duration Count Start Time)
LCOT Reverse Circuit), the PBX will start
SMDR Page Length).
Feature Guide 205