Panasonic KX-TDA100 Features Manual page 317

Configuration–Slot–E & M
Common
Parameter
Slot
Interface
First Dial Time (DID/
TIE)
Answer Detection Time Specifies the duration time that the system
Inter-digit Time
DTMF Tone
DTMF Inter-digit Pause Specifies the DTMF Inter-digit Pause Time. 64 + 16 × n (n=0–11)
Pulse Dialling
Pulse % Break
Pulse Type
Pulse Inter-digit Pause Selects the Pulse Inter-digit Pause Time.
Pulse Feed Back Tone Selects whether to turn on or off the pulse
Pulse Maximum Break
Width
Pulse Minimum Make
Width
Description
Specifies the slot no.
Selects E & M signal type.
Note
If you select "Pulsed with Answer" or
"Pulsed without Answer", you must
select "Wink" in Start Signal Type on
Page 319.
Specifies the waiting time after seizing the
DID/TIE channel, before sending the dialled
digits.
Note
It is available only when Start Signal
Type is set to "Immediate" on Page
319.
requires to recognise the answer signal.
Specifies the pseudo-answer time.
Selects the % break for pulse digits.
Selects the pulse dialling signal type.
feedback tone.
Specifies the maximum Break Width.
Specifies the minimum Make Width.
3.2 PC Programming
Value Range
PBX No.–Slot No.
(Card type is only E &
M.)
Continuous/
Pulsed with Answer/
Pulsed without
Answer/
Continuous No Answer
32 × n (n=1–255) ms
32 × n (n=1–255) ms
3–15 s
ms
60/67 %
Normal/Sweden/
New Zealand
630/830/1030 ms
Yes/No
72 + 8 × n (n=0–11) ms
8 × n (n=1–5) ms
Feature Guide 317