Panasonic KX-TDA100 Features Manual page 308

3.2 PC Programming
Parameter
DTMF Duration
Trunk Pulse Speed
Wink Signal Time-out
Start Signal Type
Sending Caller ID to
TIE
Receiving Caller ID
from TIE
Ringback Tone Service Assigns if the ringback tone is sent.
PBX Dial Tone
Pause Time
Flash Time
Disconnect Time
308 Feature Guide
Description
Selects the duration of the DTMF time.
Selects the pulse speed.
Specifies the length of time that the system
is to wait for the Wink Signal after seizing
the trunk.
Note
It is available only when Start Signal
Type is set to "Wink".
Selects the start signal type.
• Wink: The wink signal is transmitted to
the telephone company before the
incoming calls are received.
• Immediate: No wink signal is
transmitted.
Assigns whether to send TIE Caller ID to
the other PBX.
Assigns whether to receive TIE Caller ID
from the other end.
Note
It is not available when Channel Type
is L-CO or G-CO.
Assigns whether the system sends dial
tone to extension users who seize a T1
digital trunk line.
Selects the length of the Pause Time.
Specifies the length of the Flash Time.
Selects the maximum waiting time after
releasing the trunk line before getting it
again.
Value Range
80/160 ms
10/20 pps
64 × n (n=1–128) ms
Immediate/Wink
Yes/No
Yes/No
Enable/Disable
Enable/Disable
1.5/2.5/3.5/4.5 s
None/16 × n (n=1–80)
ms
0.5/1.5/2.0/4.0/12.0 s