Arming Inhibit Time; System Armed; Alarm, Inhibit Time Between Alarms And Alarm Cycles; System Disarming - Gemini 823 Series Installation And Use Manual

The inhibit arming time lasts approximately 30" and is indicated by the LED turned ON;
exit the vehicle without triggering any alarm
After the inhibit time the system is "armed" and ready to detect any theft attempt. When the system is
fully armed, the LED flashes.

2.6 - ALARM, INHIBIT TIME BETWEEN ALARMS AND ALARM CYCLES

The system will indicate theft attempt
After an alarm is triggered, but
An alarm event can generate up to 10 alarm cycles of 30" each for each input and for each arming cycle.
Press the unlock button on the vehicle original remote control
Disarming is confirmed by 2 siren chirps (if feature status has been modified) and 2 flashes of the turn
indicators.
An alarm condition is signalled by 5 acoustic signals (if feature status has been modified) and 5 flashes
of the turn indicators.
The various alarm causes and relative LED
This disarming mode is used for "EMERGENCY DISARMING" and "TOTAL DISARMING".
Touching the electronic key to its receptable disarms and switches off the system which will not rearm
if the remote control is used
To restore normal operation, touch the electronic key to its receptacle.
A quick chirp and a flash of the status LED will confirm that the system is back to normal
Five flashes of the turn indicators and five beeps
upon disarming warn that the alarm has been triggered in your absence.
To identify the last cause of alarm , turn ignition ON and count the number of flashes of the status LED.
Optical signals are repeated 3 times in a row; to interrupt, turn ignition key "OFF".
The table below lists the various alarm causes and relative number of LED flashes
LED FLASHES
LED OFF (2 seconds)
PAGE 04 - USER MANUAL
2.4 -

2.5 - SYSTEM ARMED

s by optical/acoustic signals.
before another alarm cycle starts, there is a 5 sec. "neutral time".

2.7 - SYSTEM DISARMING

2.8 - EMERGENCY DISARMING BY ELECTRONIC KEY

.

2.9 - ALARM MEMORY

LED ON (1 second)

ARMING INHIBIT TIME

.
signals are detailed in p
mode.
(siren chirps,
ALARM CAUSES
Ignition attempt (+15/54)
Volumetric or external sensor
.
aragraph (2.9).
if feature status has been modified
Door opening
Bonnet opening
Boot opening
Wire tampering
it is possible to
.
ALARM
CYCLES
10
10
10
10
10
10
)