System Programming Example - Gemini 823 Series Installation And Use Manual

10.7 - NEGATIVE OUTPUT SELECTION (DURING ALARM) FOR HORNS OR ADDITIONAL
Depending on the connection made, this function can activate the output for the siren (continuous
tone) or for the horn (intermittent tone
The following example illustrates the steps to follow to modify the programmable functions.
As mentioned before, turning the key OFF/ON disables the function, while using the electronic key
enables it. To confirm the operation, a high or low pitched signal will sound and the LED will flash as
indicated (see table, chapter
The LED will light up for about 2 seconds; during this period
Two acoustic signals (a high and a low-pitched beep) and 2 flashes of the turn indicators will
In both cases, the system moves on to the next function.
When the last function is configured (either with the electronic key or the ignition key), in addition
to the confirmation tone, the system gives 2 low-pitched and 1 high-pitched acoustic
the turn indicators flash twice to confirm the end of the programming procedure.
).

11.0 - SYSTEM PROGRAMMING EXAMPLE

10.0).
With alarm system disarmed, turn ignition key "ON".
confirm that the system has entered in programming mode.
Turn ignition "OFF" and then back "ON" to
A low-pitched acoustic signal will confirm the
OFF-ON
The LED will flash according to the selected
To enable the function, touch the electronic key
A high-pitched acoustic signal will confirm the
The LED will flash according to the selected
all the other functions.
SIREN
ON
receptacle .
disable the function.
operation.
function (from 1 to 7).
OR
once to its receptacle.
operation.
function (from 1 to 7).
Repeat steps above to enable or disable
touch the electronic key to its
INSTALLER MANUAL - PAGE 11
Boop
Beep
signals and