Deleting Programmed Devices - Gemini 823 Series Installation And Use Manual

To carry out the operation successfully, make sure the required electrical connections
!
Any previously programmed device can be erased as follows
!
With the system disarmed, open the driver door and the bonnet and leave them open
The following operations must be carried out within 4 seconds otherwise the
!
!
Turn ignition key "ON-OFF"-"ON-OFF"-"ON-OFF"-"ON".
!
At the fourth turn, leave it "ON".
!
To confirm it has entered in delete mode, the system gives 2 acoustic signals (one high and one
low-pitched sound), the turn indicators flash once and the status LED turns ON
!
Close the bonnet.
!
Keep the bonnet closed (approx. 8 sec.) until the devices are completely deleted
If the bonnet is opened before 8 seconds, the devices will not be
!
!
The status LED turns OFF when the devices have been deleted
!
Turn ignition key "OFF
!
The end of the procedure is confirmed by a long low-pitched acoustic signal.
PAGE 14 - INSTALLER MANUAL

15.0 - DELETING PROGRAMMED DEVICES

(door/bonnet switches and ignition) are complete.
procedure is invalidated.
".
.
deleted.
.
.
.
.