System Programming; Passive Arming; Boot Switch Polarity Selection; Optical Pulse Signal/Self-Powered Siren - Gemini 823 Series Installation And Use Manual

The t able below applies to the system programmed in "standard configuration".
E very time you enter the programming procedure, the alarm resets to the default settings
Exclusion of arm/disarm optic signals
Exclusion of arm/disarm acoustic signals
Arming of self-powered coded siren
Boot input, positive signal
Pulse negative output during alarm cycle
A lack of power during electrical system maintenance will not affect the programming.
The procedure must be carried out entirely. To scroll from one function to another either turn the key to
disable it or use the electronic key to enable the function (see par.11.0).
Programmable functions are briefly described below.
This function activates optic signals when the system is armed and disarmed.
If the vehicle already has optical lock/unlock signals, the turn indicators alarm flashes
!
This function activates acoustic signals when the system is armed and disarmed.
This function arms the system 60" after ignition is switched off and the last door is opened and closed.
If a door is opened during this lapse of time, the procedure is interrupted; it will resume when the door
is closed .
This function enables the relative output (20-pin connector, position 13, PINK wire) to activate the self-
powered coded siren
This function modifies the alarm input signal (positive or negative) according to the signal generated
by the boot switch .
This function activates the optical
the hook-up is to the "emergency" switch wire (Hazard button
When the optical pulse signaling feature is activated, the blinkers will ONLY emit optical
!
If the function is disabled, under normal operating conditions, the blue wire carries a negative signal;
during an alarm cycle, there is a lack of negative.
PAGE 10 - INSTALLER MANUAL

10.0 - SYSTEM PROGRAMMING

FUNCTION
System passive arming
Optical pulse signalling
10.1 - OPTICAL SIGNALS
10.2 - ACOUSTIC SIGNALS

10.3 - PASSIVE ARMING

10.4 - ENABL
(art. 7725).

10.5 - BOOT SWITCH POLARITY SELECTION

10.6 - OPTICAL PULSE SIGNAL/SELF-POWERED SIREN

signals according to the connection made; only for vehicles where
signals during an alarm cycle.
The system BLUE wire MUST be connected to the Hazard button.
In this case, do not connect the ORANGE wires (see chapter 7.3).
should be deactivated.
ING OF SIREN (7725) OUTPUT
).
STATUS LED FLASHES
Disabled
Enabled
D isabled
D isabled
D isabled
D isabled
D isabled
.