Adding New Devices - Gemini 823 Series Installation And Use Manual

To carry out the operation successfully, make sure the required electrical connections
!
!
If an extra device is added, it will automatically delete the first device programmed in the
To activate the procedure proceed as follows:
!
With the system disarmed, open the driver door and the bonnet and leave them open
The following operations must be carried out within 4 seconds otherwise the procedure
!
!
Turn ignition key "ON-OFF"-"ON-OFF"-"ON-OFF"-"ON".
!
At the fourth turn, leave it "ON".
!
To confirm it has entered in learning mode, the system gives 2 acoustic signals (one high and one
low-pitched), the turn indicators flash once and the status LED turns ON
Do not close the bonnet otherwise all previously programmed devices will be erased
!
!
The system is ready to receive the device codes.
!
Insert the electronic key into its receptacle
!
Each time a device is learned a high-pitched signal sounds and the status LED turns OFF briefly
!
R epeat this procedure to program other devices.
!
Turn ignition key
!
T o confirm the end of the procedure, a low-pitched signal sounds, the turn indicators flash once and
the status LED turns OFF.

14.0 - ADDING NEW DEVICES

(door/bonnet switches and ignition) are complete.
Storing memory is for 55 devices
as described in the next paragraph.
"OFF".
system memory .
is invalidated.
.
.
.
.
INSTALLER MANUAL - PAGE 13
.