Central Locking Connections To Arm/Disarm The System; Connections To Actuators With Separate Radio Receiver; Connections To Actuators With Lock Switches; Connections To Turn Indicators - Gemini 823 Series Installation And Use Manual

8.0 - CENTRAL LOCKING CONNECTIONS TO ARM/DISARM THE SYSTEM

Central door locking must be connected according to vehicle type (see installation schemes). Check
out the various possibilities described below and proceed with the applicable connection.
!
Arming via the lock actuators.
!
Arming via the lock actuators and the lock/unlock switches.
!
Arming via the turn indicator flashes.
!
Arming via the turn indicator flashes and the lock actuators.
!
Arming via the turn indicators flashes, the actuators and the lock/unlock switches
8.1 - CONNECTIONS TO ACTUATORS WITH A SEPARATE RADIO RECEIVER
Arm/disarm connections for vehicles with a radio receiver that is separate from CDL (see www.gemini-
alarm.com for diagram "A" connection).
Set dip-switch nr. 4 "ON".
8.2 -
Arming/disarming connections for vehicles that require connections to actuators but also require
control of lock switches or internal lock/unlock switches (see www.gemini-alarm.com for diagram
"D", "E" connection).
Set dip-switch N. 4 "ON".
If the turn indicators lock/unlock flashes are identical, connect the actuators.
If the turn indicators flash when unlocking via the car mechanical key, do not make this
!
The arm/disarm connection is made by connecting the WHITE-ORANGE wire to the turn indicators.
If the arm/disarm connection is only via the turn indicators, set dip-switch N. 4 "OFF".
If the arm/disarm connection is via the turn indicators and the actuators, set dip-switch N. 4 "ON".

9.0 - SELF-LEARNING OF TURN INDICATOR FLASHES

In order to arm/disarm via the turn indicators, the system must learn the vehicle lock (arming) and
unlock (disarming) flashes.
Connect the WHITE-ORANGE wire to the turn indicators and proceed as follows
!
Disconnect the 8-pin harness connector from the 8-pin alarm connector
!
Turn ignition key
!
Connect the 8-pin harness connector to the 8-pin alarm connector; the LED will turn ON steady
!
T urn ignition key
!
When the turn indicators stop flashing, a high-pitched acoustic signal confirms the learning of the
arming flashes .
!
Press the unlock button on the original remote control
!
When the turn indicators stop flashing, 2 high-pitched audio signals confirm the learning of the
disarming flashes
!
This completes the procedure

CONNECTIONS TO ACTUATORS WITH LOCK SWITCHES

8.3 - CONNECTIONS TO TURN INDICATORS

"ON".
"OFF", c lose all doors and press the lock button on the original remote control
.
.
connection.
.
.
:
.
INSTALLER MANUAL - PAGE 09
"C",
.
.