Advertisement
1.4 - ARMING DELAY
There is a 30 sec. delay from the time the system is armed to allow you to leave the vehicle without
triggering an alarm: it will be signaled by the LED turned ON steady.
1.5 - SYSTEM ARMED
After the arming delay the system is fully armed and ready to detect any alarm event. The LED will start
flashing to confirm the armed status.
1.6 - ALARM, NEUTRAL TIME BETWEEN ALARMS AND ALARM CYCLES
Alarm events are signaled by optical/acoustic signals
interval before another alarm can be triggered.
each input and for each arming cycle. One alarm cycle lasts for 30 sec.
1.7 - SYSTEM DISARMING
Press the unlock button on the vehicle original remote control or button
remote; system disarming is confirmed by 2 siren chirps and 2
are enabled).
If an alarm event has occurred while you were away from your vehicle, it will be signaled, when you
disarm the sytem, by 5 siren chirps and 5 flashes of the turn indicators. Alarm causes and relative LED
signals are listed in the next paragraph.
3.8 - ALARM MEMORY
The LED memory allows to identify the last alarm event signaled by 5 siren chirps and 5 turn indicator
flashes when the system is disarmed.
Turn ignition key "ON" and count the number of flashes. The status LED will flash according to the last
alarm detected prior to disarming (see table below).
The flash sequence is repeated 3 times; to interrupt turn ignition key "OFF".
The table below lists the various alarm causes and relative number of LED flashes.
LED FLASHES
LED OFF (2 seconds)
LED ON (1 second)
2.0 - GEMINI REMOTE CONTROL 738W AND BATTERY REPLACEMENT
If the right connections have been made, the vehicle doors will lock/unlock when pressing
the arming/disarming buttons.
PAGE 04
. Once the alarm ceases, there is a 5 sec. time-
Each alarm event can generate up to 10 cycles for
"2" on the Gemini 738W
flashes of the turn indicators (if signals
ALARM CAUSES
Ignition attempt (+15/54)
Door tamper
Bonnet tamper
Boot tamper
Volumetric or external sensor
Wireless magnetic contacts or
opening detectors
Wireless infrared sensors (PIR)
Wire tampering
BUTTON 1:
TOTAL SYSTEM ARMING
(and door lock)
BUTTON 3:
PARTIAL ARMING
(door lock + sensor exclusion)
If the LED blinks 3 times at the press of a button, the battery is weak and must be replaced as follows:
1
1
ATTENTION:
!
ALARM
CYCLES
The wireless waterproof digital siren with back-up battery has a transceiver which operates at a
10
frequency of approx. 2.45 GHz. The 3-wire siren, which also manages the bonnet switch, connects
10
directly to the vehicle battery with no wires to be routed from the engine compartment (siren and
bonnet switch) to the control unit inside the cabin. Use the supplied metal bracket and screws to mount
1
0
the siren to a suitable metal surface in the engine bay, away from heat sources and moving parts.
10
• The L-bracket can be attached on the long or short side (Fig.1).
1
0
• Face the siren speaker downward so as to avoid water damage (Fig.2).
10
Drill a hole using a
10
3mm drill bit.
10
ON
OFF
2
2
Use only 23AE batteries.
Risk of explosion if battery is replaced by an incorrect type.
Discard used batteries properly in special dedicated containers.
INSTALLER MANUAL
3.0 - WIRELESS SIREN 725W
CORRECT installation examples
INCORRECT installation examples
Fig.1
BUTTON 2
:
SYSTEM DISARMING
(and door unlock)
3
3
4
4
YES
NO
4
3
2
1
Fig.2
PAGE 05
Advertisement
