Advertisement
A quick
high-pitched chirp, long
a
low pitched chirp and 2 flashes of the turn indicators will confirm the
system is in programming mode.
To
A quick high-pitched chirp will confirm operation.
ON
OFF
The LED will flash according to the selected
To
A long low-pitched chirp will confirm operation.
The LED will flash according to the selected
In both cases, the system will move on to the next function.
Repeat the above steps to enable or disable the other functions.
When the last function is programmed, in addition to the confirmation tone, to
the programming procedure,
the system gives 2 low-pitched chirps, 1 high-pitched chirp and
turn indicators flash twice.
9.0
- ULTRASONIC VOLUMETRIC PROTECTION
9.1
- CONNECTIONS AND POSITIONING
Insert the WHITE connector in the "W" marked socket.
Insert the RED connector in the "R" marked socket.
Install the ultrasonic sensor
cells
on the top part of the windshield internal pillars, away from the air
vents and point them towards the center of the rear window.
13.2
- SENSOR ADJUSTMENT
To check the
sensor
sensitivity level proceed as follows
• With the alarm system disarmed, roll down the front window approx. 20 cm.
• Set the trimmer to an intermediate position (medium sensitivity).
• Close all doors, bonnet and boot and arm the system.
• During the arming delay introduce an object in the cabin through the window and move it around;
the status LED will turn off to
signal a presence.
• I
f the sensitivity level
is too high or too low, readjust the trimmer and repeat the above procedure
SENSITIVITY
ADJUSTMENT
PAGE 10
enable
the functions press once the
"ON"
BUTTON
.
function (from 1 to ).
5
OR
disable
the functions press once the
"OFF"
BUTTON
.
function (from 1 to ).
5
:
ULTRASONIC
CONNECTIONS
To carry out the operation successfully, make sure the required electrical connections
!
Beep
If there is no bonnet switch, ground the GREEN wire (20-pin connector, pos. 15).
!
If an extra device is added, it automatically deletes the first device stored in memory.
To activate the code-learning mode proceed as follows:
Boop
• With the system disarmed, open the vehicle bonnet and keep it opened or ground the GREEN wire.
The "ON-OFF" cycles must be carried out within 4 sec. otherwise the procedure is
!
• Cycle ignition key
•
At the 4th cycle leave ignition
indicate the end of
the
• A siren chirp and
will turn ON steady.
Do not close the bonnet otherwise all previously programmed devices will be erased as
!
The system is ready to receive the device codes.
1.
Depending on which device is to be paired:
• Press twice one of the buttons on the remote control;
• Make the magnetic contact transmit twice (bring contact and magnet together and then move apart);
• Press the opening detector button twice;
• D
isconnect and reconnect the siren connector.
2.
The LED will switch OFF for approx.1 sec. to confirm the device has been learned.
3.
Repeat this same procedure to learn other devices.
4.
Turn ignition key "OFF".
5.
Two low-pitched chirps and a flash of the turn indicators will confirm the end of the procedure.
.
The status LED will turn OFF.
6.
Close the bonnet or remove the GREEN wire from ground (bonnet switch).
CELLS
10.0 - LEARNING NEW DEVICES
(bonnet switch and ignition) are properly connected.
Storing memory is for 60 devices.
invalidated.
"
ON-OFF
" "
-
ON-OFF
" "
-
ON-OFF
" "
-
ON
key "ON".
2 flashes of the turn indicators
will confirm the system is in learn mode. The LED
described in the next paragraph.
"
.
PAGE 11
Advertisement
