JUKI LBH-1790 Instruction Manual page 11

Button and display
A PATTERN NEW REGISTER button
B PATTERN COPY button
C PATTERN NAME SETTING button
D PATTERN NAME display
E PRESSER DOWN button
F BOBBIN WINDER button
G PATTERN SELECTION button
H NEEDLE THREAD TENSION
SETTING button
I OVEREDGING WIDTH, LEFT
SETTING button
J KNIFE GROOVE WIDTH, LEFT
SETTING button
K DIRECT SELECTION button
Pattern No. new register screen is displayed.
→ Refer to 13. PERFORMING NEW REGISTER OF SEWING
PATTERN, p.34.
Sewing data copy screen is displayed.
17. COPYING SEWING PATTERN,
→ Refer to
Sewing pattern name input screen is displayed.
7. NAMING THE PATTERN,
→ Refer to
Name which has been inputted to the sewing pattern being selected is
displayed.
Presser down screen is displayed and the needle moves to the right
side. To raise the presser, press the presser up button displayd in the
presser down screen.
＊ When performing threading in this state, turn OFF the power before
performing.
Bobbin thread can be wound.
11. WINDING BOBBIN THREAD,
→ Refer to
Pattern No. being selected at present is displayed on this button
and when the button is pressed, the pattern No. change screen is
displayed.
6. PERFORMING PATTERN NO. SELECTION,
→ Refer to
Needle thread tension value which is set to the pattern data being
selected at present is displayed on this button and when the button is
pressed, the needle thread tension change screen is displayed.
9. CHANGING NEEDLE THREAD TENSION,
→ Refer to
Overedging width, left which is set to the pattern data being selected at
present is displayed on this button and when the button is pressed, the
overedging width, left change screen is displayed.
Knife groove width, left which is set to the pattern data being selected
at present is displayed on this button and when the button is pressed,
the knife groove width, left change screen is displayed.
When this button is pressed, the screen of pattern No. list registered to
the direct selection button is displayed.
– 10 –
Description
p.51.
p.22.
p.29.
p.20.
p.25.