Akai MPC TOUCH User Manual page 147

Assigning Samples
You can assign your new sample directly to a pad from Trim Mode.
To assign a sample, tap Assign at the bottom edge of the touchscreen to open the Assign Sample window.
Important: Assigning a sample to a pad in this way will replace the sample on the first layer of the pad.
If you set the Assign To field to Assign the slice to a pad, the pad
will simply refer to the slice in this sample instead of creating a new
sample. This is useful for reducing clutter in your project.
Use the Pad field to select the desired pad. Alternatively, press the
desired pad.
Use the Slice Type field to select how the pad's layer settings will
be set when the slice is assigned to it (see
learn more about the parameters mentioned below):
•
Non-Destructive Slice: The pad's Slice setting will be set to
the slice number.
•
Pad Parameters: The pad's Slice setting will be set to Pad.
The Pad Start and Pad End will be set to the slice's start point
and end point values, and the Loop Position will be set to the
slice's start point but with Pad Loop deactivated.
Use the Program field to specify the program to which you want to
add the slice.
To assign the sample, tap Do It.
To cancel the operation, tap Close.
Program Edit Mode to
147