Akai MPC TOUCH User Manual page 146

Use the Tune field to transpose the sample up or down from its original pitch.
Tap From BPM to open the Calculate BPM window, which
lets you tune a sample to the current sequence.
Use the Number Of Beats field to match the number of
beats in the sequence.
To tune the sample to the sequence, tap Match. The Tune
field will adjust automatically and close the window. The
sample is now tuned to the sequence.
To tune the sample to the sequence and adjust the
sequence tempo, tap To Seq. This is the same as tapping
Match but it also changes the sequence's tempo to the BPM
shown in the Tempo field on the right.
To close the window, tap Close.
Use the Root Note field to set the root note of the sample. This defines which note will play the sample
at its original pitch when in a keygroup program.
The Slice field does not work in Trim Mode.
The Link Slices button does not work in Trim Mode.
0 Snap forces start points, end points, and loop points to occur only at the waveform's "zero-
crossings." This can help to avoid clicks and glitches when playing a sample.
To enable or disable 0 Snap, press and hold Shift, and then tap 0 Snap at the bottom edge of the
touchscreen.
To enable or disable the loop function, press and hold Shift, and then tap Loop at the bottom of the
touchscreen. This switches the loop function between Forward and off. The loop function is described
earlier.
146