Low Torque Detection Signals - Toshiba TOSVERT VF-PS1 Instruction Manual

6.28 Low torque detectiosn signal
• Function
If the torque remains below the level specified with
specified with
= : Alarm signal output (No tripping)
= : Trip signal output
Title
6
<Example of operation>
Output terminal function: 142 (Low torque detection )
Ex.) When outputting low torque detection signals through output terminal OUT1
Title
Note: To put out signals to the terminal OUT2, select the parameter
Low torque
signal output
Output torque [%]
+
When
After tripping, the low torque signal remains ON.
: Undertorque detection selection
: Undertorque detection level during power running
: Undertorque detection level during regenerative braking
: Undertorque detection time
: Undertorque detection hysteresis
, the inverter will be tripped. Then the trip message "
With an output terminal function selection parameter, the inverter can be set so as to issue an
undertorque alarm.
The output terminal function number is 142 or 143 (reverse video).
If the torque is found to be below the value set with
with , the inverter will be tripped. (FL activated under a fault signal)
Function
Undertorque detection selection
Undertorque detection level during
power running
Undertorque detection level during
regenerative braking
Undertorque detection time
Undertorque detection hysteresis
= (Alarm output)
Function
Output terminal function selection 1(OUT1)
= (tripping), the inverter will trip if low torque lasts for the period of time set with
or for a period longer than that
or
Adjustment range
: Alarm mode
: Trip mode
~ %
~ %
~ sec.
~ %
Adjustment range
~
.
OFF
less than
Time [sec]
F-60
E6581386
" appears.
for a period longer than that set
Default setting
Setting value
ON
OFF
.