Toshiba TOSVERT VF-PS1 Instruction Manual page 161

3) Switching using external terminals - Switching the acceleration/deceleration time via external terminals
Output frequency [Hz]
Acceleration/deceleration
switching signal
(1) Acceleration at the gradient corresponding
to acceleration time 
(2) Acceleration at the gradient corresponding
to acceleration time 
 Setting parameters
a) Operating method: Terminal input
Set the command mode selection  to .
b) Use the S2 terminals for switching. (Instead, other terminals may be used.)
Title

Input terminal function selection 6 (S2)
 Acceleration/deceleration pattern
Acceleration/deceleration patterns can be selected individually, using the acceleration/deceleration 1 and 2
parameters.
1) Straight acceleration/deceleration
2) S-pattern acceleration/deceleration 1
3) S-pattern acceleration/deceleration 2
Title Function

Acceleration/deceleration 1 pattern

Acceleration/deceleration 2 pattern
1) Straight acceleration/deceleration
A general acceleration/deceleration pattern.
This pattern can usually be used.
Output frequency [Hz]
Maximum frequency
0
(1) (2)
Function Adjustment range
~
:Straight, :S-pattern 1, :S-pattern 2
:Straight, :S-pattern 1, :S-pattern 2

0

F-45
Time [s]
(3) (4)
(3) Deceleration at the gradient corresponding
to deceleration time 
(4) Deceleration at the gradient corresponding
to deceleration time 
Setting value
 (Acceleration/deceleration
switching signal 1)
Adjustment range
Time [s]

E6581386
6
Default setting

