Searching For All Reset Parameters And Changing Their Settings - Toshiba TOSVERT VF-PS1 Instruction Manual

5.21

Searching for all reset parameters and changing their settings


• Function
Automatically searches for only those parameters that are programmed with values different from the
standard default setting and displays them in the user parameter group . Parameter setting can also
be changed within this group.
Note 1: If you reset a parameter to its factory default, the parameter will no longer appear in .
Note 2: It may take several seconds to display changed parameters because all data stored in the user parameter
group  is checked against the factory default settings. To cancel the parameter group search in process,
press the
Note 3: Parameters which cannot be reset to the default setting after setting  to  are not displayed.
 Refer to Section 5.20 for details.
 How to search and reprogram parameters
The operations of search and resetting of parameters are as follows.
Key operated
5
MODE
ENT
ENT
or
ENT
ENT
(
(
MODE
MODE
: Automatic edit function
key.
MODE
LED display
Displays the operation frequency (operation stopped).
(When standard monitor display selection = [Output

frequency])
 The first basic parameter "History function ()" is displayed.
Press

Press the ENTER key to enable the user parameter automatic edit

function.
Searches for parameters that are different in value from the standard
default setting and displays those parameters. Press the ENTER key

or the
to search for parameters in reverse direction.)
 Press the ENTER key to display the set value.
Press the

Press the ENTER key to save the changed value. The parameter

name and the programmed value will flash on and off alternately.
Use the same steps as those given above to display parameters that

)
you want to search for or change setting with the
()
key.
)
When "" appears again, the search is ended.

A search can be canceled by pressing the MODE key. Press the key
Parameter display
once while the search is underway to return to the display of

parameter setting mode.

After that you can press the MODE key to return to the status

monitor mode or the standard monitor mode (display of operation

frequency).
Operation
or key to select .
key to change the parameter displayed. (Press the
key and key to change set value.
E-42
E6581386
key
key and