Fine-Tuning The Print Conditions - Roland DWP-80S User Manual

Fine-tuning the Print Conditions

In most cases it will not be necessary to change these settings in order to print.
Procedure
A
Click .
B
Click [Advanced Print Conditions].
The [Advanced Print Conditions] dialog box appears.
Shrinkage factor
Layer height
Resin exposure
time
Reset
M E M O
The standard values (recommended values) for each setting under [Advanced Print Conditions] will vary according
to the application type.
Correct for the shrinkage factor (magnification correction amount in the XY
direction during exposure). Increase the shrinkage factor using +, and decrease
the shrinkage factor using –.
Unit: [%]
Setting range: -5.0 to +5.0%
Set the layer pitch.
Unit: [mm], [inch]
Options: 0.05, 0.10, 0.15 [mm]
Set the resin exposure time.
Unit: [sec]
Setting range: 2.00 to 50.00 [sec]
Reset all settings to the standard value for the selected application (job type).
Use Advanced/Useful Functions
Chapter 2 Output
43